ATO Error Message STP

  • 1
  • Question
  • Updated 1 week ago
  • Answered
Any hints on how to resolve this error message after uploading 

Error message


·         The requestId is valid, and the Pull request is waiting in the queue.

Many Thanks
Photo of Anna Hopkins

Anna Hopkins

  • 126 Points 100 badge 2x thumb

Posted 3 months ago

  • 1
Photo of Rav

Rav, Community Manager

  • 61,234 Points 50k badge 2x thumb
Hi Anna,
Check out the link below for info on that message -

The request is valid but the pull request is yet to be queued - Single Touch Payroll
Photo of Anna Hopkins

Anna Hopkins

  • 126 Points 100 badge 2x thumb
Thanks
Photo of Jill Torning

Jill Torning

  • 60 Points
Hi Rav
All of my uploads since 06 July  all has this error message. How long does it take before the messages will change?
Photo of Rav

Rav, Community Manager

  • 61,194 Points 50k badge 2x thumb
Hi Jill,
It sounds like there could be something else happening there if its been this long without any change in status.

The most common cause is due to the Software ID from GovConnect STP not being registered with the ATO.

Can you please take a look at these two articles and confirm that the Software ID that is listed in the Company & Advisers section of GovConnect STP has been registered with the ATO either through the ATO Access Manager or by phone -

Where is my Software ID for GovConnect Single Touch Payroll (STP)?

Single Touch Payroll - AUSkey and Software ID FAQ's