Jobkeeper in Reckon Hosted

  • 1
  • Question
  • Updated 2 months ago
Hi I did the jobkeeper in my payrun for the week ending 29.04.2020 using
 JOBKEEPER-START-FN01. I was told I would only have to do this at the beginning as my employees earn over the $1500 allowance and then at the end using
 JOBKEEPER-FINISH-FN06. I was told I don't have to do anything else in Reckon I only have to advise the ATO monthly through the ATO portal. Is this correct?
Photo of Vicki Jonas

Vicki Jonas

  • 332 Points 250 badge 2x thumb

Posted 2 months ago

  • 1
Photo of Bruce

Bruce

  • 3,256 Points 3k badge 2x thumb
You are essentially correct. 

However, note that there are going to be 13 fortnights for JobKeeper so we will be finishing with JOBKEEPER-FINISH-FN13 rather than 06.   

However, if any of your employees cease to be eligible for JobKeeper, e.g. they resign, then you would use JOBKEEPER-FINISH-FNXX where xx is the appropriate fortnight.
Photo of Simone Farrell

Simone Farrell

  • 238 Points 100 badge 2x thumb
Hi Vicki,
The following webinar from Reckon will give you all of the information you need. 
https://www.youtube.com/watch?v=kCAASHuJyJE&feature=youtu.be&app=desktop