STP Submission Errors

  • 1
  • Question
  • Updated 1 week ago

After receiving the latest email from Reckon thought I would check on the status of my STP

The following error messages have been returned from the ATO and need to be reviewed. You may need to make changed in your accounting product before submitting again.

Error message

  • The request Id is valid, but the pull request is yet to be queued.
I had a bit of a look through the other questions/help on this forum but couldn't see that anyone had this exact issue. Your help with this error is greatly appreciated.

Photo of BMR Accounts

BMR Accounts

  • 104 Points 100 badge 2x thumb

Posted 1 week ago

  • 1
Photo of Rav

Rav, Community Manager

  • 61,090 Points 50k badge 2x thumb
Hi BMR,

Please see this existing thread for this status message - 

The request is valid but the pull request is yet to be queued - Single Touch Payroll

In saying that, how long ago was this pay event submitted?
Photo of BMR Accounts

BMR Accounts

  • 104 Points 100 badge 2x thumb

Hi Rav,
Weekly from the 4/7. and they all have the same message?
Photo of Rav

Rav, Community Manager

  • 61,090 Points 50k badge 2x thumb
Can I grab the ABN in question and I'll ask our STP folks to take a closer look
Photo of BMR Accounts

BMR Accounts

  • 104 Points 100 badge 2x thumb

Sure the ABN is 62 159 284 189
Thanks
Photo of BMR Accounts

BMR Accounts

  • 104 Points 100 badge 2x thumb

Rav, I'm leaving work now but will check in next week to see if you have had any luck. Thanks for your help
Photo of Rav

Rav, Community Manager

  • 61,090 Points 50k badge 2x thumb
I've just heard back in regard to your submissions, and there are a couple of things to cover.

The first being, the reason your submissions have not proceeded further is due to your Software ID not being registered. What you'll need to do is grab the Software ID from GovConnect and register it with the ATO either through the ATO Access Manager or by giving them a call.
There's more info and step by step instructions in this article -
Single Touch Payroll - AUSkey and Software ID FAQ's

The secondary aspect is the status message you were being presented. You should have received a status message that referred to the Software ID rather than the status outlined in your opening post. The next time you login to GovConnect can I get you to perform a hard refresh by pressing Ctrl & F5. Once completed, does the status message update?