Leave Balance and accrual value Report not correct

Patrick_8319167
Patrick_8319167 Member Posts: 40 Reckoner Reckoner

Hi,

I’m experiencing an issue with the leave balances and accrual value report in Reckon One. I noticed that the OTE value calculation for one of the employee’s annual leave, long service leave, and personal leave is based on their previous salary instead of their latest annual salary after the review. I tried deleting and re-entering the salary in the employee’s details, but the problem persists. Has anyone else encountered this issue or knows how to resolve it?

Answers

  • Tanvi_kataria
    Tanvi_kataria Reckon Staff Posts: 359 Reckon Staff

    Hi @Patrick_8319167

    This could be possibly happening because of delayed update of the employee record. Please try the following steps -

    • Delete the Salary Item from the Employee Record - Pay Set-up as in the screenshot attached below:
    • Navigate to the Pay run and undo it.
    • Next, re-add the Salary Item to the record.
    • After that, remove the pay item from the pay run and then add it back again.

    Please follow these steps and check if the issue persists. I hope this helps. If you have any concerns, feel free to reach out. Thank you!

    Regards

    Tanvi

  • Patrick_8319167
    Patrick_8319167 Member Posts: 40 Reckoner Reckoner

    Hi Tanvi,

    I followed those steps, and the OTE value was updated to use the latest salary for calculation. However, after deleting the pay run, the OTE value reverted to using the previous salary. Is there another way to fix this?

    Regards

    Patrick